ZyXEL PLA-400 Manuel d'utilisateur télécharger pdf (Page 45)

Chapter 5 LEDs and Troubleshooting

PLA-4xx Series User’s Guide

Figure 35 PLA-470 LEDs

The following table describes the LED behavior.

5.2 Power and LED Problems

V The PLA-4xx does not turn on. None of the LEDs turn on.

1 Make sure you are using the power cord included with the PLA-4xx.

2 Make sure the power cord is connected to the PLA-4xx and plugged in to an appropriate

power source. Make sure the power source is turned on.

3 Disconnect and re-connect the power cord to the PLA-4xx.

4 Remove the powerline adapter from the outlet. Then connect an electrical device that

you know works into the same power outlet. This checks the status of the power outlet.

5 If the problem continues, contact the vendor.

V The ETHN LED does not turn on.

Table 8 PLA-470 LEDs

LED ICON STATUS DESCRIPTION

POWER On The PLA-470 is on and receiving power.

Off The PLA-470 is not receiving power.

LINK On The POWER port detects another powerline adapter.

Blinking The PLA-470 is communicating with another powerline

adapter.

Off The POWER port is not detecting another powerline

adapter.

ETHERNET On The ETHERNET port is on and ready and the PLA-470

detects a device connected to it.

Blinking The PLA-470 is communicating with a router, modem,

switch or a computer connected to it.

Off The PLA-470 does not detect any devices connected to

its ETHERNET port.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 65 66

Pas de commentaire

ZyXEL PLA-400 Manuel d'utilisateur Page 45