ZyXEL ZyAIR G-360 Manuel d'utilisateur télécharger pdf (Page 48)

ZyXEL G-360 User’s Guide

6-2 Adapter

You can enable OTIST using the reset button or the web configurator. If you use the reset button, the

default (01234567) or previous saved (through the web configurator) Setup Key is used to encrypt the

settings that you want to transfer.

Hold in the Reset button for one or two seconds.

If you hold in the Reset button too long, the device will reset to the factory

defaults!

In the web configurator, go to the Wireless LAN main screen and then select OTIST. To change the Setup

Key, enter up to eight printable characters. To have OTIST automatically generate a WPA(2)-PSK key,

select the Yes check box. If you manually configured a WEP key or a WPA(2)-PSK key and you also

selected this check box, then the key you manually configured is used.

6.1.2 Starting OTIST

You must click Start in the AP OTIST web configurator screen and in the wireless client(s) Adapter

screen all within three minutes (at the time of writing). You can start OTIST in the wireless clients and AP

in any order but they must all be within range and have OTIST enabled.

1. In the AP, a web configurator screen pops up showing you the security settings to transfer. After

reviewing the settings, click OK.

2. This screen appears while OTIST settings are being transferred. It closes when the transfer is

complete.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 94 95

Pas de commentaire

ZyXEL ZyAIR G-360 Manuel d'utilisateur Page 48