ZyXEL MSAP2000 Manuel d'utilisateur télécharger pdf (Page 238)

238

MSAP2000 AAMS User’s Guide

If your FTP client does not allow you to have a destination filename different than

the source, you will need to rename them as the MSAP2000 AAMS only

recognizes “config-0” and “ras”. Be sure you keep unaltered copies of the files for

later use.

The following table is a summary. Please note that the internal filename refers to

the filename on the MSAP2000 AAMS and the external filename refers to the

filename not on the MSAP2000 AAMS, that is, on your computer, local network or

FTP site and so the name (but not the extension) may vary. After uploading new

firmware, use the

sys version command to confirm that you have uploaded the

correct firmware version.

Table 67 File Name Conventions

FILE TYPE INTERNAL NAME EXTERNAL NAME DESCRIPTION

Configuration File config-0 *.dat This is the configuration filename for the

MSAP2000 AAMS.

Firmware ras *.bin This is the generic name for the ZyNOS

firmware on the MSAP2000 AAMS.

31.3 Editable Configuration File

The configuration file can be downloaded as a plain-text (ASCII) file.

Edits to the configuration can be made to this file before it is uploaded

again to the MSAP2000 AAMS.

Note: You can change the “.dat” file to a “.txt” file and still upload it to the

MSAP2000 AAMS.

31.3.1 Editable Configuration File Backup

Configure your system, and then use FTP to backup the plain-text configuration

file onto your computer. Do the following to backup the configuration file:

Use an FTP client to connect to the MSAP2000 AAMS.

C:\> ftp <MSAP2000 AAMS IP address>

Enter the User name (just press [ENTER]).

User: [ENTER]

Enter the management password (1234 by default).

Password: 1234

230 Logged in

Use get to transfer the configuration file to the computer. The configuration file on the

system

(that you want to backup to the computer) is named

config-0.

ftp> get config-0

1 2 ... 233 234 235 236 237 238 239 240 241 242 243 ... 247 248

Pas de commentaire

ZyXEL MSAP2000 Manuel d'utilisateur Page 238