ZyXEL NBG420N Manuel d'utilisateur télécharger pdf (Page 107)

Chapter 7 Wireless LAN

NBG420N User’s Guide

107

7.9.2 WPS Station Screen

Use this screen when you want to add a wireless station using WPS. To open this screen, click

Network > Wireless LAN > WPS Station tab.

" Note: After you click Push Button on this screen, you have to press a similar

button in the wireless station utility within 2 minutes. To add the second

wireless station, you have to press these buttons on both device and the

wireless station again after the first 2 minutes.

Figure 71 WPS Station

The following table describes the labels in this screen.

7.9.3 Scheduling

Use this screen to set the times your wireless LAN is turned on and off. Wireless LAN

scheduling is disabled by default. The wireless LAN can be scheduled to turn on or off on

certain days and at certain times. To open this screen, click Network > Wireless LAN >

Scheduling tab.

Table 38 WPS Station

LABEL DESCRIPTION

Push Button Use this button when you use the PBC (Push Button Configuration) method to

configure wireless stations’s wireless settings. See Section 6.1.2.1 on page 74.

Click this to start WPS-aware wireless station scanning and the wireless security

information synchronization.

Or input station’s

PIN number

Use this button when you use the PIN Configuration method to configure wireless

station’s wireless settings. See Section 6.1.2.2 on page 75.

Type the same PIN number generated in the wireless station’s utility. Then click

Start to associate to each other and perform the wireless security information

synchronization.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 339 340

Pas de commentaire

ZyXEL NBG420N Manuel d'utilisateur Page 107