ZyXEL NBG420N Manuel d'utilisateur télécharger pdf (Page 196)

Chapter 16 Static Route Screens

NBG420N User’s Guide

196

Figure 118 Management > Static Route > IP Static Route

The following table describes the labels in this screen.

16.2.1 Static Route Setup Screen

To edit a static route, click the edit icon under Modify. The following screen displays. Fill in

the required information for each static route.

Table 69 Management > Static Route > IP Static Route

LABEL DESCRIPTION

# This is the index number of an individual static route. The first entry is for the

default route and not editable.

Name This is the name that describes or identifies this route.

Active This icon is turned on when this static route is active.

Click the Edit icon under Modify and select the Active checkbox in the Static

Route Setup screen to enable the static route. Clear the checkbox to disable this

static route without having to delete the entry.

Destination This parameter specifies the IP network address of the final destination. Routing

is always based on network number.

Gateway This is the IP address of the gateway. The gateway is an immediate neighbor of

your NBG420N that will forward the packet to the destination. On the LAN, the

gateway must be a router on the same segment as your NBG420N; over the

WAN, the gateway must be the IP address of one of the remote nodes.

Modify Click the Edit icon to open the static route setup screen. Modify a static route or

create a new static route in the Static Route Setup screen.

Click the Remove icon to delete a static route.

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 339 340

Pas de commentaire

ZyXEL NBG420N Manuel d'utilisateur Page 196