ZyXEL P-2302R Manuel d'utilisateur télécharger pdf (Page 145)

P-2302R Series User’s Guide

Chapter 13 Static Route 144

Figure 56 Edit IP Static Route

The following table describes the labels in this screen.

Table 40 Edit IP Static Route

LABEL DESCRIPTION

Route Name Enter the name of the IP static route. Leave this field blank to delete this static route.

Active This field allows you to activate/deactivate this static route.

Destination IP

Address

This parameter specifies the IP network address of the final destination. Routing is

always based on network number. If you need to specify a route to a single host, use

a subnet mask of 255.255.255.255 in the subnet mask field to force the network

number to be identical to the host ID.

IP Subnet Mask Enter the IP subnet mask here.

Gateway IP

Address

Enter the IP address of the gateway. The gateway is a router or switch on the same

network segment as the device's LAN or WAN port. The gateway helps forward

packets to their destinations.

Metric Metric represents the “cost” of transmission for routing purposes. IP routing uses

hop count as the measurement of cost, with a minimum of 1 for directly connected

networks. Enter a number that approximates the cost for this link. The number need

not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good

number.

Private This parameter determines if the Prestige will include this route to a remote node in

its RIP broadcasts.

Select this check box to keep this route private and not included in RIP broadcasts.

Clear this check box to propagate this route to other hosts through RIP broadcasts.

Apply Click Apply to save your changes back to the Prestige.

Cancel Click Cancel to exit this screen without saving.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 383 384

Pas de commentaire

ZyXEL P-2302R Manuel d'utilisateur Page 145