ZyXEL P-2302R Manuel d'utilisateur télécharger pdf (Page 258)

P-2302R Series User’s Guide

257 Chapter 27 Static Route Setup

Figure 124 Menu12.1 Edit IP Static Route

The following table describes the fields for Menu 12.1 – Edit IP Static Route Setup.

Menu 12.1 - Edit IP Static Route

Route #: 2

Route Name= ?

Active= No

Destination IP Address= ?

IP Subnet Mask= ?

Gateway IP Address= ?

Metric= 2

Private= No

Press ENTER to Confirm or ESC to Cancel:

Table 108 Menu12.1 Edit IP Static Route

FIELD DESCRIPTION

Route # This is the index number of the static route that you chose in menu 12.1.

Route Name Type a descriptive name for this route. This is for identification purpose only.

Active This field allows you to activate/deactivate this static route.

Destination IP Address This parameter specifies the IP network address of the final destination.

Routing is always based on network number. If you need to specify a route to

a single host, use a subnet mask of 255.255.255.255 in the subnet mask field

to force the network number to be identical to the host ID.

IP Subnet Mask Type the subnet mask for this destination. Follow the discussion on IP

Subnet Mask in this manual.

Gateway IP Address Type the IP address of the gateway. The gateway is an immediate neighbor

of your Prestige that will forward the packet to the destination. On the LAN,

the gateway must be a router on the same segment as your Prestige; over

WAN, the gateway must be the IP address of one of the remote nodes.

Metric Metric represents the “cost” of transmission for routing purposes. IP routing

uses hop count as the measurement of cost, with a minimum of 1 for directly

connected networks. Type a number that approximates the cost for this link.

The number need not be precise, but it must be between 1 and 15. In

practice, 2 or 3 is usually a good number.

Private This parameter determines if the Prestige will include the route to this remote

node in its RIP broadcasts. If set to Yes, this route is kept private and is not

included in RIP broadcasts. If No, the route to this remote node will be

propagated to other hosts through RIP broadcasts.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC

to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.

1 2 ... 253 254 255 256 257 258 259 260 261 262 263 ... 383 384

Pas de commentaire

ZyXEL P-2302R Manuel d'utilisateur Page 258