ZyXEL P-2302R Manuel d'utilisateur télécharger pdf (Page 313)

P-2302R Series User’s Guide

Chapter 33 Firmware and Configuration File Maintenance 312

4 Enter your password as requested (the default is “1234”).

5 Enter “bin” to set transfer mode to binary.

6 Use “put” to transfer files from the computer to the Prestige, for example, “put

firmware.bin ras” transfers the firmware on your computer (firmware.bin) to the Prestige

and renames it “ras”. Similarly, “put config.rom rom-0” transfers the configuration file

on your computer (config.rom) to the Prestige and renames it “rom-0”. Likewise “get

rom-0 config.rom” transfers the configuration file on the Prestige to your computer and

renames it “config.rom.” See earlier in this chapter for more information on filename

conventions.

7 Enter “quit” to exit the ftp prompt.

Note:

The Prestige automatically restarts after a successful file upload.

33.4.4 FTP Session Example of Firmware File Upload

Figure 180 FTP Session Example of Firmware File Upload

More commands (found in GUI-based FTP clients) are listed earlier in this chapter.

33.4.5 TFTP File Upload

The Prestige also supports the uploading of firmware files using TFTP (Trivial File Transfer

Protocol) over LAN. Although TFTP should work over WAN as well, it is not recommended.

To use TFTP, your computer must have both telnet and TFTP clients. To transfer the firmware

and the configuration file, follow the procedure shown next.

1 Use telnet from your computer to connect to the Prestige and log in. Because TFTP does

not have any security checks, the Prestige records the IP address of the telnet client and

accepts TFTP requests only from this address.

2 Put the SMT in command interpreter (CI) mode by entering 8 in Menu 24 – System

Maintenance.

3 Enter the command “sys stdio 0” to disable the management session idle timeout, so the

TFTP transfer will not be interrupted. Enter “command sys stdio 5” to restore the five-

minute management session idle timeout (default) when the file transfer is complete.

331 Enter PASS command

Password:

230 Logged in

ftp> bin

200 Type I OK

ftp> put firmware.bin ras

200 Port command okay

150 Opening data connection for STOR ras

226 File received OK

ftp: 1103936 bytes sent in 1.10Seconds 297.89Kbytes/sec.

ftp> quit

1 2 ... 308 309 310 311 312 313 314 315 316 317 318 ... 383 384

Pas de commentaire

ZyXEL P-2302R Manuel d'utilisateur Page 313