ZyXEL NBG420N Manuel d'utilisateur télécharger pdf (Page 81)

Chapter 6 Tutorials

NBG420N User’s Guide

6.2.1 Configuring Bob’s NBG420N VPN Settings

To configure these settings Bob uses the NBG420N web configurator.

1 Log into the NBG420N web configurator and click VPN > Modify icon. This displays

the VPN Rule Setup (basic) screen.

2 Select the Active checkbox to enable the VPN rule after it has been created. Make sure

IKE is selected as the IPSec Keying Mode.

Figure 45 Property

3 Enter the IP address “192.168.1.35” in the Local Address text box. This is the IP

address of Bob’s computer. Enter the IP address “192.168.1.35” in the Local Address

End/Mask text box. This value is the same as Bob only wants Jack to access this single

IP address.

Figure 46 Local Policy

4 Enter the IP address “10.0.0.7” in the Remote Address Start text box. This is the IP

address of Jack’s computer. Enter the IP address “10.0.0.7” in the Remote Address

Local ID Type IP IP

Local Content 1.1.1.1 2.2.2.2

Secure Gateway

Address

2.2.2.2 1.1.1.1

Peer ID Type IP IP

Peer Content 2.2.2.2 1.1.1.1

Encapsulation

Mode

Tunnel Tunnel

IPSec Protocol ESP ESP

Pre-Shared Key ThisIsMySecretKey ThisIsMySecretKey

Encryption

Algorithm

3DES 3DES

Authentication

Algorithm

SHA1 SHA1

Table 26 Site-To-Site VPN Tunnel Settings (continued)

SETTING BOB’S NBG420N JACK’S NBG420N

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 339 340

Pas de commentaire

ZyXEL NBG420N Manuel d'utilisateur Page 81